Uniden WHAMx4BK Manual do Operador descarregar pdf (Página 30)

Vivace Boat Information Book Web Version (BIB) (Rev February 13, 2014)

Revision 6 Page | 30

8. Re-install sump drain valve cap.

9. Close vent plug and tighten snugly.

10. Fully open fuel shut-off valve.

11. Brief draining of the filter can be accomplished without losing prime through

the filter. If a large quantity of fuel has been drained, leave the fuel valve

closed and follow the Primary fuel filter priming procedure, below.

Primary fuel filter change procedure (see exploded parts diagram below)

1. Make sure engine is off and cool to touch.

2. When opening any part of the fuel system, be ready with drip containers and

absorbent material to prevent fuel contamination of bilge that will be pumped

overboard. A drip pan, waste fluids bottle and funnels are under the starboard

settee.

3. Close shut-off valve between fuel tank and filter (top of fuel tank).

4. Drain filter assembly of fuel.

5. Loosen head bolt with a 15/16" wrench.

6. Spin bowl and element (together) off of mounting head.

7. Spin collection bowl off and save.

8. Dispose of filter properly.

9. Lubricate new seals with motor oil or clean fuel and install only with new filter.

10. Install new O-ring onto collection bowl.

11. Install collection bowl onto new filter.

12. Install new gasket onto new filter.

13. Follow priming Instructions, below.

Primary fuel filter priming procedure (see exploded parts diagram below)

1. Close shut-off valve between fuel tank and filter.

2. When opening any part of the fuel system, be ready with drip containers and

absorbent material to prevent fuel contamination of bilge that will be pumped

overboard. A drip pan, waste fluids bottle and funnels are under the starboard

settee.

3. Open vent plug on mounting head with a 1/2" wrench (silver bolt on side of

mounting head).

4. Slowly open shut-off valve until fuel begins to spill out of vent port. This may

be slow—allow up to 2 minutes for fuel to appear.

5. Close and tighten vent plug.

6. Spin bowl and filter (together) onto mounting head tighten by hand - do not

use tools.

7. Fully open fuel shut-off valve.

8. Bleeding of fuel system is not necessary if this procedure has been followed.

9. Start engine and check for leaks.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Sem comentários

Uniden WHAMx4BK Manual do Operador Página 30