Uniden WHAMx4BK Manual do Operador descarregar pdf (Página 50)

Vivace Boat Information Book Web Version (BIB) (Rev February 13, 2014)

Revision 6 Page | 50

Caution

During change out, the Raymarine ST-40 depth speed log and the

through hull plug will leak unless:

1. The o-rings are coated with Vaseline (a tube is kept at the

through hull);

2. The large arrow is pointed forward;

3. The unit is PUSHED downward until it clicks into a detent

that can be felt through the unit.

4. The locking ring is torqued hand tight, only.

Speed Transducer. The transducer is normally removed and replaced with

a plug when the speed sensing system is not in use. This prevents fouling

of the rotor with marine organisms. The speed transducer and plug each

have two o-rings to seal the through hull. The o-rings require application

of Vaseline during each installation to prevent leakage. Each component

has a large arrow molded into the top. The arrow must point forward for a

water tight seal.

Depth and Speed Display

The display vertical arrangement of data fields is controllable by the

operator. The lower field is large font, the upper field is smaller font.

To invert the data display, depress and release bottom button:

Caution

The V-berth bilge is NOT served by the bilge pump. Strict

compliance with the following procedures is required to avoid bilge

water accumulation. Water must be removed manually. Monitor the

bilge periodically after installing the speed transducer or plug.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 73 74

Sem comentários

Uniden WHAMx4BK Manual do Operador Página 50